그렇게 많은 IT인증덤프공부자료를 제공하는 사이트중ITExamDump의 인지도가 제일 높은 원인은 무엇일가요?그건ITExamDump의 제품이 가장 좋다는 것을 의미합니다. ITExamDump에서 제공해드리는 Cisco인증 350-001덤프공부자료는Cisco인증 350-001실제시험문제에 초점을 맞추어 시험커버율이 거의 100%입니다. 이 덤프만 공부하시면Cisco인증 350-001시험패스에 자신을 느끼게 됩니다.
Cisco 350-001인증시험은 전문적인 관련지식을 테스트하는 인증시험입니다. ITExamDump는 여러분이Cisco 350-001인증시험을 통과할 수 잇도록 도와주는 사이트입니다. 여러분은 응시 전 저희의 문제와 답만 잘 장악한다면 빠른 시일 내에 많은 성과 가 있을 것입니다.
수많은Cisco인증 350-001시험공부자료중에서ITExamDump의Cisco인증 350-001덤프가 가장 출중한 원인은 무엇일가요? ITExamDump의Cisco인증 350-001덤프는 실제시험문제의 출제방향을 연구하여 IT전문가로 되어있는 덤프제작팀이 만든 최신버전 덤프입니다. ITExamDump의Cisco인증 350-001덤프가 있으면 힘든Cisco인증 350-001시험이 쉬어져서 자격증을 제일 빠른 시간내에 취득할수 있습니다.제일 어려운 시험을 제일 간단한 방법으로 패스하는 방법은ITExamDump의Cisco인증 350-001덤프로 시험준비 공부를 하는것입니다.
ITExamDump의 Cisco인증 350-001덤프는 거의 모든 실제시험문제 범위를 커버하고 있습니다.Cisco인증 350-001시험덤프를 구매하여 덤프문제로 시험에서 불합격성적표를 받을시ITExamDump에서는 덤프비용 전액 환불을 약속드립니다.
시험 번호/코드: 350-001
시험 이름: Cisco (CCIE Routing and Switching Written)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 508 문항
업데이트: 2013-10-20
Cisco인증 350-001시험은 IT업종종사분들에게 널리 알려진 유명한 자격증을 취득할수 있는 시험과목입니다. Cisco인증 350-001시험은 영어로 출제되는만큼 시험난이도가 많이 높습니다.하지만 ITExamDump의Cisco인증 350-001덤프만 있다면 아무리 어려운 시험도 쉬워집니다. 오르지 못할 산도 정복할수 있는게ITExamDump제품의 우점입니다. ITExamDump의Cisco인증 350-001덤프로 시험을 패스하여 자격증을 취득하면 정상에 오를수 있습니다.
350-001 덤프무료샘플다운로드하기: http://www.itexamdump.com/350-001.html
NO.1 The classic Spanning Tree Protocol (802.1D 1998) uses which sequence of variables to determine the
best received BPDU?
A. 1) lowest root bridge id,
2) lowest sender bridge id,
3) lowest port id,
4) lowest root path cost
B. 1) lowest root path cost,
2) lowest root bridge id,
3) lowest sender bridge id,
4) lowest sender port id
C. 1) lowest root bridge id,
2) lowest sender bridge id,
3) lowest root path cost
4) lowest sender port id
D. 1) lowest root bridge id,
2) lowest root path cost,
3) lowest sender bridge id,
4) lowest sender port id
Answer: D
Cisco기출문제 350-001덤프 350-001 350-001기출문제 350-001 dumps
NO.2 Why does RSTP have a better convergence time than 802.1D?
A. It is newer
B. It has smaller timers
C. It has less overhead
D. It is not timer-based
Answer: D
Cisco최신덤프 350-001 350-001 350-001 pdf 350-001 350-001
NO.3 When STP UplinkFast is enabled on a switch utilizing the default bridge priority, what will the new bridge
priority be changed to?
A. 8192
B. 16384
C. 49152
D. 65535
Answer: C
Cisco 350-001자격증 350-001자료
NO.4 Loop guard and UniDirectional Link Detection both protect against Layer 2 STP loops. In which two
ways does loop guard differ from UDLD in loop detection and prevention? (Choose two)
A. Loop guard can be used with root guard simultaneously on the same port on the same VLAN while
UDLD cannot.
B. UDLD protects against STP failures caused by cabling problems that create one-way links.
C. Loop guard detects and protects against duplicate packets being received and transmitted on different
ports.
D. UDLD protects against unidirectional cabling problems on copper and fiber media.
E. Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a
designated switch port
Answer: BE
Cisco 350-001 350-001 dump 350-001 350-001 dumps
NO.5 Prior to 802.1w, Cisco implemented a number of proprietary enhancements to 802.1D to improve
convergence in a Layer 2 network. Which statement is correct?
A. Only UplinkFast and BackboneFast are specified in 802.1w; PortFast must be manually configured.
B. Only PortFast is specified in 802.1w; UplinkFast and BackboneFast must be manually configured.
C. None of the proprietary Cisco enhancements are specified in 802.1w.
D. PortFast, UplinkFast, and BackboneFast are specified in 802.1w.
Answer: D
Cisco 350-001 350-001 350-001 pdf
NO.6 Spanning Tree Protocol IEEE 802.1s defines the ability to deploy which of these?
A. one global STP instance for all VLANs
B. one STP instance for each VLAN
C. one STP instance per set of VLANs
D. one STP instance per set of bridges
Answer: C
Cisco 350-001시험문제 350-001시험문제 350-001
NO.7 You have done a partial migration from 802.1D STP to 802.1w STP. Which of the following is true?
A. 802.1D and 802.1w interoperate only when the 802.1D STP domain supports rapid convergence.
B. Ports leading to 802.1D devices will run in compatibility mode, while the rest of the ports will run in
802.1w mode.
C. This is an invalid configuration and a partial migration cannot be done.
D. The bridge timers will be set to match the 802.1D devices.
E. A secondary root bridge will always be populated within the 802.1D domain.
F. If the root bridge is selected within the 802.1D domain, the whole STP domain will run in 802.1D
compatibility mode.
G. In partially migrated 802.1w networks, it is recommended to keep the STP diameter below 4.
Answer: B
Cisco시험문제 350-001 350-001
NO.8 Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree
Protocol IEEE 802.1D.? (Choose two)
A. Designated Root Cost
B. bridge ID priority
C. max age
D. bridge ID MAC address
E. Designated Root Priority
F. forward delay
Answer: BD
Cisco인증 350-001 350-001시험문제
NO.9 Which standard supports multiple instances of spanning tree?
A. 802.1D
B. 802.1s
C. 802.1w
D. 802.1z
Answer: B
Cisco 350-001 350-001 350-001 350-001 350-001덤프
NO.10 Which three port states are used by RSTP 802.1w? (Choose three.)
A. Listening
B. Learning
C. Forwarding
D. Blocking
E. Discarding
F. Disabled
Answer: BCE
Cisco 350-001 350-001 350-001 350-001
NO.11 What two features in Cisco switches help prevent Layer 2 loops? (Choose two)
A. UniDirectional Link Detection
B. Hot Standby Router Protocol
C. Virtual Router Redundancy Protocol
D. PortFast
E. Root guard
F. Loop guard
Answer: AF
Cisco 350-001기출문제 350-001 350-001 350-001 dumps
NO.12 Under which two circumstances would an RSTP bridge flush its CAM table? (Choose two)
A. Upon a port state change
B. Upon receiving a topology change notification
C. When transitioning from discarding to forwarding
D. When transitioning from forwarding to discarding
E. Only when changing from listening to discarding
F. When CAM resources have been completely used up
Answer: BC
Cisco 350-001 dump 350-001 350-001 350-001
NO.13 Refer to the exhibit.
In the diagram, the switches are running IEEE 802.1s MST. Which ports are in the MST blocking state?
A. GE-1/2 and GE-2/1
B. GE-1/1 and GE-2/2
C. GE-3/2 and GE-4/1
D. no ports are in the blocking state
E. There is not enough information to determine which ports are in the blocking state.
Answer: D
Cisco 350-001 350-001 350-001기출문제 350-001
NO.14 Which of these correctly identifies a difference between the way BPDUs are handled by 802.1w and
802.1D?
A. 802.1D bridges do not relay BPDUs.
B. 802.1w bridges do not relay BPDUs.
C. 802.1D bridges only relay BPDUs received from the root.
D. 802.1w bridges only relay BPDUs received from the root.
Answer: C
Cisco최신덤프 350-001자격증 350-001 350-001 dumps
NO.15 What is the purpose of the STP PortFast BPDU guard feature?
A. enforce the placement of the root bridge in the network
B. ensure that a port is transitioned to a forwarding state quickly if a BPDU is received
C. enforce the borders of an STP domain
D. ensure that any BPDUs received are forwarded into the STP domain
Answer: C
Cisco 350-001 350-001덤프 350-001최신덤프 350-001최신덤프
NO.16 If a port configured with STP loop guard stops receiving BPDUs, the port will be put into which state?
A. learning state
B. listening state
C. forwarding state
D. loop-inconsistent state
Answer: D
Cisco덤프 350-001 pdf 350-001 350-001자격증
NO.17 Refer to the exhibit.
Which switching feature is being tested?
A. loop guard
B. PortFast
C. root guard
D. BDPU guard
Answer: A
Cisco 350-001 350-001 dumps 350-001시험문제
NO.18 As a network administrator, can you tell me what the root guard feature provides in a bridged network?
A. It ensures that BPDUs sent by the root bridge are forwarded in a timely manner
B. It enforces the root bridge placement in the network
C. It ensures that all ports receiving BPDUs from the root bridge are in the forwarding state.
D. It ensures that the bridge is elected as Root Bridge in the network.
Answer: B
Cisco자격증 350-001기출문제 350-001 350-001시험문제
NO.19 Refer to the exhibit.
In the diagram, the switches are running IEEE 802.1w RSPT.
On which ports should root guard be enabled in order to facilitate deterministic root bridge election under
normal and failure scenarios?
A. GE-3/1, GE-3/2
B. FE-2/1, FE-3/2
C. GE-1/1.GE-1/2
D. GE-4/1, GE-4/2
E. GE-2/1, GE-2/2
F. GE-3/1, GE-3/2, GE-4/1, GE-4/2, FE-2/1, FE-3/2
Answer: F
Cisco 350-001 dumps 350-001 350-001 350-001인증
NO.20 Spanning Tree Protocol calculates path cost based on which of these?
A. interface bandwidth
B. interface delay
C. interface bandwidth and delay
D. hop count
E. bridge priority
Answer: A
Cisco 350-001자료 350-001 350-001시험문제
ITexamdump의 BAS-004덤프의 VCE테스트프로그램과 FCNSA.v5덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 1Z0-466시험에 대비한 고품질 덤프와 3107시험 최신버전덤프를 제공해드립니다. 최고품질 70-410시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기