351-001 덤프 Cisco 자격증 덤프

ITExamDump는 여러분의 요구를 만족시켜드리는 사이트입니다. 많은 분들이 우리사이트의 it인증덤프를 사용함으로 관련it시험을 안전하게 패스를 하였습니다. 이니 우리 ITExamDump사이트의 단골이 되었죠. ITExamDump에서는 최신의Cisco 351-001자료를 제공하며 여러분의Cisco 351-001인증시험에 많은 도움이 될 것입니다.

ITExamDump의Cisco 351-001인증시험의 자료 메뉴에는Cisco 351-001인증시험실기와Cisco 351-001인증시험 문제집으로 나누어져 있습니다.우리 사이트에서 관련된 학습가이드를 만나보실 수 있습니다. 우리 ITExamDump의Cisco 351-001인증시험자료를 자세히 보시면 제일 알맞고 보장도가 높으며 또한 제일 전면적인 것을 느끼게 될 것입니다.

ITExamDump를 선택함으로, ITExamDump는 여러분Cisco인증351-001시험을 패스할 수 있도록 보장하고,만약 시험실패시 ITExamDump에서는 덤프비용전액환불을 약속합니다.

많은 분들이 고난의도인 IT관련인증시험을 응시하고 싶어 하는데 이런 시험은 많은 전문적인 IT관련지식이 필요합니다. 시험은 당연히 완전히 전문적인 IT관련지식을 터득하자만이 패스할 가능성이 높습니다. 하지만 지금은 많은 방법들로 여러분의 부족한 면을 보충해드릴 수 있으며 또 힘든 IT시험도 패스하실 수 있습니다. 혹은 여러분은 전문적인 IT관련지식을 터득하자들보다 더 간단히 더 빨리 시험을 패스하실 수 있습니다.

ITExamDump 에서 제공해드리는 Cisco 351-001덤프는 아주 우수한 IT인증덤프자료 사이트입니다. IT업계엘리트한 강사들이 퍼펙트한 Cisco 351-001 덤프문제집을 제작하여 디테일한 시험문제와 답으로 여러분이 아주 간단히Cisco 351-001시험을 패스할 수 있도록 최선을 다하고 있습니다.

시험 번호/코드: 351-001

시험 이름: Cisco (CCIE Routing and Switching Written)

351-001 덤프무료샘플다운로드하기: http://www.itexamdump.com/351-001.html

NO.1 Prior to 802.1w, Cisco implemented a number of proprietary enhancements to 802.1D to improve
convergence in a Layer 2 network. Which statement is correct?
A. Only UplinkFast and BackboneFast are specified in 802.1w; PortFast must be manually configured.
B. Only PortFast is specified in 802.1w; UplinkFast and BackboneFast must be manually configured.
C. None of the proprietary Cisco enhancements are specified in 802.1w.
D. PortFast, UplinkFast, and BackboneFast are specified in 802.1w.
Answer: D

Cisco dump   351-001 pdf   351-001   351-001

NO.2 Under which two circumstances would an RSTP bridge flush its CAM table? (Choose two)
A. Upon a port state change
B. Upon receiving a topology change notification
C. When transitioning from discarding to forwarding
D. When transitioning from forwarding to discarding
E. Only when changing from listening to discarding
F. When CAM resources have been completely used up
Answer: BC

Cisco   351-001   351-001   351-001

NO.3 If a port configured with STP loop guard stops receiving BPDUs, the port will be put into which state?
A. learning state
B. listening state
C. forwarding state
D. loop-inconsistent state
Answer: D

Cisco   351-001   351-001자료   351-001

NO.4 What two features in Cisco switches help prevent Layer 2 loops? (Choose two)
A. UniDirectional Link Detection
B. Hot Standby Router Protocol
C. Virtual Router Redundancy Protocol
D. PortFast
E. Root guard
F. Loop guard
Answer: AF

Cisco   351-001   351-001   351-001최신덤프   351-001   351-001

NO.5 What is the purpose of the STP PortFast BPDU guard feature?
A. enforce the placement of the root bridge in the network
B. ensure that a port is transitioned to a forwarding state quickly if a BPDU is received
C. enforce the borders of an STP domain
D. ensure that any BPDUs received are forwarded into the STP domain
Answer: C

Cisco   351-001   351-001   351-001

NO.6 Spanning Tree Protocol IEEE 802.1s defines the ability to deploy which of these?
A. one global STP instance for all VLANs
B. one STP instance for each VLAN
C. one STP instance per set of VLANs
D. one STP instance per set of bridges
Answer: C

Cisco   351-001시험문제   351-001자료

NO.7 Which three port states are used by RSTP 802.1w? (Choose three.)
A. Listening
B. Learning
C. Forwarding
D. Blocking
E. Discarding
F. Disabled
Answer: BCE

Cisco덤프   351-001   351-001   351-001   351-001

NO.8 Why does RSTP have a better convergence time than 802.1D?
A. It is newer
B. It has smaller timers
C. It has less overhead
D. It is not timer-based
Answer: D

Cisco   351-001   351-001시험문제   351-001 dump   351-001

NO.9 Refer to the exhibit.
In the diagram, the switches are running IEEE 802.1s MST. Which ports are in the MST blocking state?
A. GE-1/2 and GE-2/1
B. GE-1/1 and GE-2/2
C. GE-3/2 and GE-4/1
D. no ports are in the blocking state
E. There is not enough information to determine which ports are in the blocking state.
Answer: D

Cisco인증   351-001   351-001기출문제   351-001   351-001   351-001

NO.10 As a network administrator, can you tell me what the root guard feature provides in a bridged network?
A. It ensures that BPDUs sent by the root bridge are forwarded in a timely manner
B. It enforces the root bridge placement in the network
C. It ensures that all ports receiving BPDUs from the root bridge are in the forwarding state.
D. It ensures that the bridge is elected as Root Bridge in the network.
Answer: B

Cisco자격증   351-001   351-001덤프   351-001덤프

NO.11 Which of these correctly identifies a difference between the way BPDUs are handled by 802.1w and
802.1D?
A. 802.1D bridges do not relay BPDUs.
B. 802.1w bridges do not relay BPDUs.
C. 802.1D bridges only relay BPDUs received from the root.
D. 802.1w bridges only relay BPDUs received from the root.
Answer: C

Cisco덤프   351-001   351-001

NO.12 Refer to the exhibit.
In the diagram, the switches are running IEEE 802.1w RSPT.
On which ports should root guard be enabled in order to facilitate deterministic root bridge election under
normal and failure scenarios?
A. GE-3/1, GE-3/2
B. FE-2/1, FE-3/2
C. GE-1/1.GE-1/2
D. GE-4/1, GE-4/2
E. GE-2/1, GE-2/2
F. GE-3/1, GE-3/2, GE-4/1, GE-4/2, FE-2/1, FE-3/2
Answer: F

Cisco dumps   351-001   351-001시험문제   351-001자격증

NO.13 Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree
Protocol IEEE 802.1D.? (Choose two)
A. Designated Root Cost
B. bridge ID priority
C. max age
D. bridge ID MAC address
E. Designated Root Priority
F. forward delay
Answer: BD

Cisco자료   351-001   351-001

NO.14 The classic Spanning Tree Protocol (802.1D 1998) uses which sequence of variables to determine the
best received BPDU?
A. 1) lowest root bridge id,
2) lowest sender bridge id,
3) lowest port id,
4) lowest root path cost
B. 1) lowest root path cost,
2) lowest root bridge id,
3) lowest sender bridge id,
4) lowest sender port id
C. 1) lowest root bridge id,
2) lowest sender bridge id,
3) lowest root path cost
4) lowest sender port id
D. 1) lowest root bridge id,
2) lowest root path cost,
3) lowest sender bridge id,
4) lowest sender port id
Answer: D

Cisco인증   351-001   351-001

NO.15 Refer to the exhibit.
Which switching feature is being tested?
A. loop guard
B. PortFast
C. root guard
D. BDPU guard
Answer: A

Cisco   351-001   351-001   351-001시험문제   351-001   351-001

NO.16 When STP UplinkFast is enabled on a switch utilizing the default bridge priority, what will the new bridge
priority be changed to?
A. 8192
B. 16384
C. 49152
D. 65535
Answer: C

Cisco   351-001   351-001   351-001

NO.17 Which standard supports multiple instances of spanning tree?
A. 802.1D
B. 802.1s
C. 802.1w
D. 802.1z
Answer: B

Cisco   351-001   351-001   351-001   351-001

NO.18 You have done a partial migration from 802.1D STP to 802.1w STP. Which of the following is true?
A. 802.1D and 802.1w interoperate only when the 802.1D STP domain supports rapid convergence.
B. Ports leading to 802.1D devices will run in compatibility mode, while the rest of the ports will run in
802.1w mode.
C. This is an invalid configuration and a partial migration cannot be done.
D. The bridge timers will be set to match the 802.1D devices.
E. A secondary root bridge will always be populated within the 802.1D domain.
F. If the root bridge is selected within the 802.1D domain, the whole STP domain will run in 802.1D
compatibility mode.
G. In partially migrated 802.1w networks, it is recommended to keep the STP diameter below 4.
Answer: B

Cisco   351-001기출문제   351-001   351-001 dumps   351-001인증

NO.19 Spanning Tree Protocol calculates path cost based on which of these?
A. interface bandwidth
B. interface delay
C. interface bandwidth and delay
D. hop count
E. bridge priority
Answer: A

Cisco   351-001   351-001   351-001덤프

NO.20 Loop guard and UniDirectional Link Detection both protect against Layer 2 STP loops. In which two
ways does loop guard differ from UDLD in loop detection and prevention? (Choose two)
A. Loop guard can be used with root guard simultaneously on the same port on the same VLAN while
UDLD cannot.
B. UDLD protects against STP failures caused by cabling problems that create one-way links.
C. Loop guard detects and protects against duplicate packets being received and transmitted on different
ports.
D. UDLD protects against unidirectional cabling problems on copper and fiber media.
E. Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a
designated switch port
Answer: BE

Cisco   351-001 dumps   351-001 dump   351-001

ITExamDump의 제품을 구매하시면 우리는 일년무료업데이트 서비스를 제공함으로 여러분을 인증시험을 패스하게 도와줍니다. 만약 인증시험내용이 변경이 되면 우리는 바로 여러분들에게 알려드립니다.그리고 최신버전이 있다면 바로 여러분들한테 보내드립니다. ITExamDump는 한번에Cisco 351-001인증시험을 패스를 보장합니다.